Motion Detector Module, ZS11 |
Phone: 813-262-0680 Send Email |
 Related Links
Specifications Power Requirements Part No. ZS11-A: 85-264 VAC, 50/60 Hz Part No. ZS11-D: 9-36 VDC, 50/60 Hz Current Draw Part No. ZS11-A: 116 mA Part No. ZS11-D: 116 mA Circuit Protection ZS11 Motion Detector Module: Internal ½ amp fuse (non-replaceable) ZS11 Relay Contacts: An external 5 amp fuse is recommended. Sensor Input Signal: 12VDC, 3 wire, sourcing (PNP) or sinking (NPN) Dimensions (in inches) 4-5/8" Wide x 3-1/2" High* x 3-3/4" Deep *including DIN Rail Mount and Terminal Block Relay
Indicators and Terminal Block  The following examples of ZS11 Motion Detector Module Systems Consist of:
|
Benefits
The ZS11 Motion Detector Module contains three relay outputs which operate via a single sensor input signal. Each relay output is adjustable, providing three independent speed level settings in one module. ZS11 can be integrated with existing industrial control systems or used as a stand-alone unit. It is DIN rail mountable for easy installation. Detail The Phares Electronics Model ZS11 Motion Detection System consists of the ZS11 Motion Detector Module, Sensor (hall effect, inductive, capacitive, photoeye, encoder, etc.), and Sensor Target, all sold seperately. The Sensor Target can be a bolt head, geartooth, key, magnet, reflector, or other target depending upon type of Sensor used. The Sensor Target is attached to or located at the point of measure. Motion is detected when the Sensor Target rotates, and passes by the Sensor. When motion is either detected or reaches setpoint, the relay outputs change state. They remain in this state until either under speed or zero speed condition occurs, depending upon application. Use the ZS11 for over speed, under speed, and zero speed applications. The ZS11 Motion Detector Module supplies 12 VDC to an external Sensor. The Sensor must be 3 wire, sourcing (PNP) or sinking (NPN) signal. Sensor types used with the ZS11:
|
