Motion Detector Module, ZS10 |
Phone: 727-623-0894 Send Email |
 Part No. ZS10-A: 85-264 VAC Part No. ZS10-D: 9-36 VDC |
Overview Simple On/Off Sensor + ZS10 Motion Detector Module = Zero Speed Switch The ZS10 Motion Detector Module is an interface between simple on/off sensors and control circuitry enabling over speed, under speed and zero speed measurement. The ZS10 is particularly useful in applications where environmental conditions prohibit the use of certain electronics. In these cases, the sensor is installed in the prohibitive area and wired to the ZS10 Motion Detector Module which is located out of the prohibitive area. Use for applications in locations classified as hazardous only when properly coupled with UL approved intrinsically safe barriers and sensors. ZS10 Operations Manual How to Order Technical Application Notes: Coal Conveyor in High Temperature Environment in Power Plant |
Benefits
Applications
|
Features
|
Detail
The Phares Electronics Model ZS10 Zero Speed Switch System consists of the ZS10 Motion Detector Module, Sensor and Sensor Target.
The Sensor Target can be a bolt head, geartooth, key, magnet, reflector, or other target depending upon type of Sensor used.
External sensor types which may be used with the ZS10 include:
- Hall Effect
- Photoeye
- Inductive
- Capacitive
- Encoder
When motion is either detected or reaches setpoint, the relay energizes and the relay output changes state. It remains in this state until either under speed or zero speed condition occurs, depending upon the application.
The ZS10 Motion Detector Module has 3 diagnostic LED's. These LED's indicate Power, Pulses from Sensor input signal and Relay status. LED's are labeled Power, Pulse, and Relay. There is a trim pot which is used for adjusting the setpoint.
The ZS10 Motion Detector Module supplies 12 VDC to an external Sensor. The Sensor must be 3 wire, sourcing (PNP) or sinking (NPN) signal. Sensor input signal is configured via two position selector switch located at the top right of the terminal strip.
ZS10 Zero Speed Switch System
Utilizing Radial Magnetic Target Disk
The above example of a ZS10 Zero Speed Switch System consists of:
Utilizing Radial Magnetic Target Disk
- ZS10 Motion Detector Module
- Sensor (sold separately)
- Sensor Target (sold separately)
- Terminal Strip Assembly (TSA) Box (sold separately)
Specifications
Power Requirements
Part No. ZS10-A: 85-264 VAC, 50/60 Hz
Part No. ZS10-D: 9-36 VDC, 50/60 Hz
Input Signal
Input Signal: 12VDC, 3 wire, sourcing (PNP) or sinking (NPN)
Dimensions (in inches)
3-1/16 " Wide x 3-1/4" High* x 2-1/2" Deep
*including DIN Rail Mount and Terminal Block
Relay
- Output:
3 SPDT Form 'C' dry relay contacts (N.O/N.C.)
- Contact Rating:
5 A at 120 VAC; 5 A at 30 VDC